All commands start with a ‘~’ (tilde) character and end with a ‘\n’ (newline).
Commands are not case-sensitive and the order of command words does not matter.
|
~device print temperature |
Print the temperature of all system thermistors (see also ~sensor print temperature). |
|
~device set current limit:#.## |
Set the current limit in Amps. Valid arguments are 2 and 5; Also responds with the lamp maximum command (0-100). |
|
~device print current limit |
Print the current limit in Amps. |
|
~device print voltage |
Print the measured supply voltage and capacitor voltage. |
|
~device print capacitor threshold voltage |
Print the capacitor threshold voltage. |
|
~device print led type |
Print the type of LED and driver connected to the controller. |