Skip to main content
Skip table of contents

Quick Start: Benthic HDE - Ethernet

Required Components

Rayfin

Interface cable

Windows PC or laptop

AC-DC power supply (24VDC)

Cat5e Ethernet cable

Router or Ethernet network

  1. Ensure the software is installed by following this section: Software Install - ROM and Firmware update process | SW Install

  2. Plug the 13-pin interface cable into the camera.

  3. Connect Interface Cable to the network or a router with DHCP. The Windows PC or tablet has to be on the same network as the Rayfin. 

  4. Connect the AC-DC power supply cable to the Interface Cable

  5. Follow this section Ethernet Connection to connect to the camera from the Rayfin Control Software. 

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.