DCS - Rayfin + MantaRay Mounting

• Place the MantaRay ① on top of the Rayfin ② such that the center of the laser apertures are aligned horizontally with respect to the front face of the Rayfin as shown in Image A.

A

• Wrap a 316 stainless steel hose clamp, 3-1/8"- 6" clamp ID, 1/2" band ③ around the Rayfin and MantaRay. The hose clamp should slide through the rear slotted groove in the MantaRay holder ⑤. Place a strip of rubber material ④ between the hose clamp and the outside surface of the Rayfin housing.

B

• Image C shows how the rubber strip should be cut, with a gap left for the MantaRay holder to fit between. Tighten the hose clamp, but not fully, so that the MantaRay position can be adjusted.

C

• Place the Rayfin and MantaRay on the Rayfin/MantaRay mount assembly ⑥. Make sure that the Rayfin is oriented correctly as shown in Image D. The front of the Rayfin should point towards the curved side of the Rayfin/MantaRay mount.

D

• If the devices are crooked, loosen the hose clamps, realign the devices and re-tighten the hose clamps.

E