DCS - Rayfin (No Lasers) and Rayfin + Skate Mounting

Rayfin w/ no lasers Installation

• Place the Rayfin ① onto the Rayfin/MantaRay mount assembly ② with the camera facing towards the curved side of the mount. The front face of the Rayfin should be positioned 62mm ahead of the front V-notch of the mount assembly (dimension shown in Image A).

A

• Fasten the Rayfin to the mount assembly using a 316 stainless steel hose clamp, 3-1/8"- 6" clamp ID, 1/2" band ③ with a strip of rubber ④ underneath it to protect the camera housing.

B

• The hose clamp should pass through the slot cutout ⑤ in the angled holder top component of the mount.

_{Note: The rubber does not need to wrap around the full circumference of the Rayfin; It only needs to cover the metal-to-metal areas where the hose clamp makes contact with the housing.}

Rayfin and Skate Installation

• Installation of the Rayfin with the Skate laser is identical to the above instructions with the exception that the Rayfin/MantaRay ② is replaced with the Rayfin/Skate mount assembly ⑥. 

• Place the Skate ⑦ on the bottom of the Rayfin/Skate mount assembly with its front face flush with the front V-notch of the mount (shown in Image C).

C

• Fasten the Skate to the mount using a 316 stainless steel hose clamp, 3-5/16" - 4-1/4" clamp ID, 1/2" band ⑧ with a strip of rubber ⑨ underneath. The hose clamp should pass through the cutout in the angled holder component as shown in Image D.

D