DCS - Deployment Operation (Boom Arm Example) | SubC Drop Camera System Manual

Deploying the system off a vessel using a boom arm (exact steps determined in integration meetings)

READ WINCH MANUAL BEFORE OPERATING. Refer to Winch Safety Page Before Operating

Deployment Operation

NOTE: Depending on the kind of vessel and type of deployment equipment, you may want to have the vessel moving before deploying the equipment, or after it is already in the water.

This is specific to the situation and should be determined based on what must be done to keep things clear of the propellers and to meet any applicable safety regulations.

As a laser safety precaution, please ensure the BPC is powered OFF before deployment.
Connect the utility winch to the TCS frame and lift to clear the side railing.
Swing the TCS frame out over the railing and then gently set the chain into the water.
Lower the frame into the water.
Disconnect the utility winch line from the TCS.
Allow the frame to trail into the water.
Using the electronic winch, raise the clump weight high enough to swing out over the deck. For safety, guide it with a boat hook.
Lower the clump weight into the water until it is just fully submerged.